Engraving
Fill
Speed350 mm/s
Power20%
Interval0.065 mm
Air Assist ON
Did these settings work for you?
Notes
Source: Boss Laser official recommended settings, shared on LightBurn Forum, 2019. Boss LS-3655 100W CO2. Starting point only — test on scrap first.
View Full Settings (25 parameters)
Cut Settings Editor — LightBurn
00
NameC00Output
Speed350.0mm/sec
FrequencyDefault
Max Power20.00%
Global Passes1
ModeFill ▾
Bi-directional fillCross-Hatch
Line Interval (mm)0.0650
Lines per Inch390.769
Scan Angle (deg)0
Number of Passes1
Angle IncrementDefault
Auto-RotateFlood Fill
Wobble
DefaultStep
DefaultSize
Fill all shapes at onceFill groups togetherFill shapes individually
Enable dot-width adjust
Dot Width:Default
Ramp Length0.00
Ramp Outer Edge← scroll to see full settings →
New