Speed40 mm/s
Power45%
Interval—
Thickness: 4mm
Did these settings work for you?
Notes
Source: clvLabs/lightburn-material-lbraries on GitHub (GPL-3.0). OMTech 60W CO2 makerspace settings. Starting point only — test on scrap first.
View Full Settings (6 parameters)
Cut Settings Editor — LightBurn
00
NameC00Output
Speed40.0mm/sec
FrequencyDefault
Max Power45.00%
Global Passes1
ModeCut ▾
Kerf OffsetDefaultmm
Perf. Cut LengthDefaultmm
Perf. SkipDefaultmm
Start DelayDefaultms
End DelayDefaultms
Dot Spacing0.010mm
Dot Time1.00ms
Enable dot-width adjust
Dot Width:Default
Ramp LengthDefault
Ramp Outer Edge← scroll to see full settings →
New