Line

Speed600 mm/s

Power10%

Interval—

Did these settings work for you?

Notes

Source: clvLabs/lightburn-material-lbraries on GitHub (GPL-3.0). OMTech 60W CO2 makerspace settings. Starting point only — test on scrap first.

View Full Settings (8 parameters)

Cut Settings Editor — LightBurn

NameC00Output

Speed600.0mm/sec

FrequencyDefault

Max Power10.00%

Global Passes2

ModeCut ▾

Kerf OffsetDefaultmm

Perf. Cut LengthDefaultmm

Perf. SkipDefaultmm

Start DelayDefaultms

End DelayDefaultms

Dot Spacing0.010mm

Dot Time1.00ms

Enable dot-width adjust

Dot Width:Default

Ramp LengthDefault

Ramp Outer Edge

← scroll to see full settings →

New

Shared by Community Sourced · 1w ago