Deep Mark
Fill
OMTech 80W Fiber MOPA · 160mm
Speed400 mm/s
Power60%
Frequency40 kHz
Interval0.01 mm
Did these settings work for you?
Notes
Source: LightBurn Forum, 2024. 80W JPT MOPA Fiber, 160mm lens (110x110 work area). Works on any 80W JPT MOPA (OMTech, Monport, etc). Starting point only — test on scrap first.
View Full Settings (22 parameters)
Cut Settings Editor — LightBurn
00
NameC00Output
Sub-Layer NameOutput Sub-Layer
Speed400.0mm/sec
Frequency40.00kHz
Max Power60.00%
Global Passes1
ModeFill ▾
Min PowerDefault%
Max Power 220.00%
Bi-directional fillCross-Hatch
Line Interval (mm)0.0100
Lines per Inch2540.000
Scan Angle (deg)0
Number of Passes1
Angle IncrementDefault
Auto-RotateFlood Fill
Wobble
DefaultStep
DefaultSize
Fill all shapes at onceFill groups togetherFill shapes individually
Enable dot-width adjust
Dot Width:Default
Ramp LengthDefault
Ramp Outer Edge← scroll to see full settings →
New