Light Engrave
Fill
OMTech 80W Fiber MOPA · 160mm
Speed1800 mm/s
Power22%
Frequency70 kHz
Interval0.025 mm
Did these settings work for you?
Notes
Source: LightBurn Forum, 2024. 80W JPT MOPA Fiber, 160mm lens (110x110 work area). Works on any 80W JPT MOPA (OMTech, Monport, etc). Starting point only — test on scrap first.
View Full Settings (13 parameters)
Cut Settings Editor — LightBurn
00
NameC00Output
Speed1800.0mm/sec
Frequency70.00kHz
Max Power22.00%
Global Passes1
ModeFill ▾
Min Power12.00%
Max Power 222.00%
Bi-directional fillCross-Hatch
Line Interval (mm)0.0250
Lines per Inch1016.000
Scan Angle (deg)0
Number of Passes1
Angle IncrementDefault
Auto-RotateFlood Fill
Wobble
DefaultStep
DefaultSize
Fill all shapes at onceFill groups togetherFill shapes individually
Enable dot-width adjust
Dot Width:Default
Ramp LengthDefault
Ramp Outer Edge← scroll to see full settings →
New