1mm Depth Outline
Line
Speed400 mm/s
Power15%
Interval—
Did these settings work for you?
Notes
Frequency is very important when cutting Acryl, lower values (1-2kHz) work well to prevent only melting the material. Multiple Passes at lower Power produce cleaner cuts than a Single Pass at higher Power.
View Full Settings (9 parameters)
Cut Settings Editor — LightBurn
00
NameC00Output
Speed400.0mm/sec
FrequencyDefault
Max Power15.00%
Global Passes1
ModeCut ▾
Kerf OffsetDefaultmm
Perf. Cut LengthDefaultmm
Perf. SkipDefaultmm
Start DelayDefaultms
End DelayDefaultms
Dot SpacingDefaultmm
Dot Time1.00ms
Enable dot-width adjust
Dot Width:Default
Ramp LengthDefault
Ramp Outer Edge← scroll to see full settings →
New