1mm Depth Fill
Fill
Speed400 mm/s
Power15%
Interval—
Did these settings work for you?
Notes
Frequency is very important when cutting Acryl, lower values (1-2kHz) work well to prevent only melting the material. Multiple Passes at lower Power produce cleaner cuts than a Single Pass at higher Power.
View Full Settings (13 parameters)
Cut Settings Editor — LightBurn
00
NameC00Output
Speed400.0mm/sec
FrequencyDefault
Max Power15.00%
Global Passes1
ModeFill ▾
Bi-directional fillCross-Hatch
Line Interval (mm)Default
Lines per InchDefault
Scan Angle (deg)0
Number of Passes1
Angle IncrementDefault
Auto-RotateFlood Fill
Wobble
DefaultStep
DefaultSize
Fill all shapes at onceFill groups togetherFill shapes individually
Enable dot-width adjust
Dot Width:Default
Ramp LengthDefault
Ramp Outer Edge← scroll to see full settings →
New