3D Slice
Image
OMTech 80W Fiber MOPA · 160mm
Speed1300 mm/s
Power45%
Frequency50 kHz
Interval0.025 mm
Did these settings work for you?
Notes
Source: LightBurn Forum, 2024. 80W JPT MOPA Fiber, 160mm lens (110x110 work area). Works on any 80W JPT MOPA (OMTech, Monport, etc). Starting point only — test on scrap first.
View Full Settings (26 parameters)
Cut Settings Editor — LightBurn
00
NameC00Output
Sub-Layer NameOutput Sub-Layer
Speed1300.0mm/sec
Frequency50.00kHz
Max Power45.00%
Global Passes1
ModeImage ▾
Min Power17.00%
Max Power 227.00%
Bi-directionalNegative Image
Line Interval (mm)0.0250
DPI1246
Scan Angle (deg)0
PPIDefault
Dither Mode3dslice
Auto-RotateFlood Fill
Wobble
DefaultStep
DefaultSize
Fill all shapes at onceFill groups togetherFill shapes individually
Enable dot-width adjust
Dot Width:Default
Ramp LengthDefault
Ramp Outer Edge← scroll to see full settings →
New