Cutting-1/8"

Line

Speed12 mm/s

Power75%

Interval0.065 mm

Air Assist ONThickness: 3.18mm

Did these settings work for you?

Notes

Source: Boss Laser official recommended settings, shared on LightBurn Forum, 2019. Boss LS-3655 100W CO2. Starting point only — test on scrap first.

View Full Settings (24 parameters)

Cut Settings Editor — LightBurn

NameC00Output

Speed12.0mm/sec

FrequencyDefault

Max Power75.00%

Global Passes1

ModeCut ▾

Kerf OffsetDefaultmm

Perf. Cut Length0.010mm

Perf. Skip0.010mm

Start Delay0.00ms

End Delay0.00ms

Dot Spacing0.100mm

Dot Time1.00ms

Enable dot-width adjust

Dot Width:Default

Ramp Length0.00

Ramp Outer Edge

← scroll to see full settings →

New

Shared by Community Sourced · 1w ago