Cut 0.5mm (Approx. 24 Sheet Gauge)
Line
OMTech 80W Fiber MOPA · 160mm
Speed15 mm/s
Power100%
Frequency100 kHz
Interval0.025 mm
Thickness: 0.5mm
Did these settings work for you?
Notes
Source: LightBurn Forum, 2024. 80W JPT MOPA Fiber, 160mm lens (110x110 work area). Works on any 80W JPT MOPA (OMTech, Monport, etc). Starting point only — test on scrap first.
View Full Settings (8 parameters)
Cut Settings Editor — LightBurn
00
NameC00Output
Speed15.0mm/sec
Frequency100.00kHz
Max Power100.00%
Global Passes1
ModeCut ▾
Min Power80.00%
Max Power 2100.00%
Kerf OffsetDefaultmm
Perf. Cut LengthDefaultmm
Perf. SkipDefaultmm
Start DelayDefaultms
End DelayDefaultms
Dot SpacingDefaultmm
Dot TimeDefaultms
Enable dot-width adjust
Dot Width:Default
Ramp LengthDefault
Ramp Outer Edge← scroll to see full settings →
New