Fill (hard)
Fill
Speed100 mm/s
Power40%
Interval—
Did these settings work for you?
Notes
Source: clvLabs/lightburn-material-lbraries on GitHub (GPL-3.0). OMTech 60W CO2 makerspace settings. Starting point only — test on scrap first.
View Full Settings (13 parameters)
Cut Settings Editor — LightBurn
00
NameC00Output
Speed100.0mm/sec
FrequencyDefault
Max Power40.00%
Global Passes1
ModeFill ▾
Bi-directional fillCross-Hatch
Line Interval (mm)Default
Lines per InchDefault
Scan Angle (deg)0
Number of Passes1
Angle IncrementDefault
Auto-RotateFlood Fill
Wobble
DefaultStep
DefaultSize
Fill all shapes at onceFill groups togetherFill shapes individually
Enable dot-width adjust
Dot Width:Default
Ramp LengthDefault
Ramp Outer Edge← scroll to see full settings →
New